![]() ![]() If you find the base pin of your Ruger backing out under heavy loads, chances are the latch does not fit properly. I have never installed a stronger spring. if you over tighten the nut just a teeny bit too much, it bends the pin, which causes the cylinder to bind. you need to keep the teeny allen wrench handy, andĢ. The reason I don't use the set screw models anymore isġ. Don't remember whether I used a drill or a metal punch, it was quite a while ago. I used the method where I tightened the screw to make a dimple, then I enlarged the dimple slightly. Which can be a pain in the neck because you need to keep the tiny allen wrench handy. Yes, to remove the pin you need to loosen the set screw. I only used one of the pins with a set screw once. I have installed a bunch of Belt Mountain pins in my Vaqueros and Colts. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |